Casting Workshop VII
I casted the model one more time today, and it went very well = all three points with "eyes" were intact! Left overs from the perevious...
Casting Workshop VI
We casted in bronze today. Unfortunately the outcome wasn't totally complete so we'll have to cast again this week. What went wrong was...
Casting Workshop V
Today we printed the 3d models and prepared them for casting! The machine prints a raft and a support structure when it's printing the...
Case Study
I have been working on a case study on StemCloud Vol2.0 by Ecologic Studio. Here is a brief introduction to what it is about, followes by...
Casting Workshop VI
3D modelling a joint piece for a lantern with 20 pieces in collaboration with the rest of the studio. We had a template with three...
Casting Workshop III
Since the aluminium cast didn't go as planned, I made one more mold to test if bronze will flow differently and fill more of the mold....
Casting Workshop II
Today we casted in aluminium. The plaster casts have been in the oven all night and burned all the material away, leaving a nice mold for...
Casting Workshop I
Casting in Aluminium 1. Make positive form in burnable material 2. Cast in plaster 3. Burn plaster cast in clayoven - this way you get...
Arduino Workshop II
In my group we decided to make a light sensitive selfregulationg curtain. Next time we will use a little time to color coordinate the...
Arduino Workshop I
Today we started the Arduino workshop...
